In my last post I taught you how to forward a port on the ASA 5505 running version 8.3 from the CLI. Some of you prefer to use the ASDM to do you changes, so I guess I’ll show you how to do it from there. The ASDM is a bit of a learning curve for someone that’s used to the CLI, and most CLI guys hate a GUI with a great passion. I can go either way. I use the ASDM to make some changes simply because I want to learn it and there’s some guys coming into the field today that were taught on the GUI rather than a command line.
In this lesson I’m using ASDM version 6.3(1) and ASA version 8.3(1). Since we added a web server in the last post, let’s make this one an FTP server. The FTP server’s IP is the same as the web server, 10.9.8.7/24 and we’re running over the standard FTP port, 21.
First off, we want to start up the ASDM and connect to the ASA. Once there, click on the button at the top of the screen, then the button near the bottom left, and finally select near the top left. You’ll now be at a screen that looks something like this:
Now we need to create a new object, so click on “Add” under Addresses, then “Network Object”.
Now we need to fill out our new window. Once you fill out the name, IP address and description, you need to drop down the NAT box and fill it out. Click the “Add Automatic Address Translation Rules” box, leave the type as “static” and set the translated address as the outside interface.
We now need to go to the Advanced menu from the Add Network Object window and setup the port forwarding. The source will be inside, destination is outside. Protocol in this instance is TCP and our port is 21, both real and mapped.
Click “OK” twice and your object will be created as well as the port forward. Now we just need to add the access rule. On the left side of the screen, just above the NAT Rules is your Access Rules. From there we want to click “Add” and “Access Rule”.
We need to create the rule on the outside interface, coming from any IP to the FTPServer using FTP as the service.
Once you click OK, your rule is added. You don’t have to add a description like I did in the image above this one, I just did that for the hell of it. When you click “Apply” at the bottom of the screen, the ASDM will issue the commands to the ASA. I have preview turned on, so I can always see what commands are being sent to the device before they are actually sent. If you followed all the steps above and you have preview turned on, you’ll see the following:
And you’ll notice that those are the exact 4 commands that I gave in the last post about doing it from the CLI! Now you can forward any port you want from either the CLI or the ASDM!
On a side note, I know a lot of guys hate the ASDM. When I was writing this post and going through all of this I was kinda upset when I saw that I had 10 pictures for 4 lines of code. The good thing about the ASDM is that you have everything right there at your disposal and you really don’t need to know the vernacular of IOS. The drawback is that it will take you longer to get things done at first, but once you get used to it, it can be just as fast.